FEATURES:
Fits the 2001-2007 Subaru WRX/STI
Intercooler design optimized for maximum flow, and smooth cast end tanks allow the best possible airflow in and out of the intercooler
Optimal core design for maximum cooling efficiency with minimal pressure drop
Flow rated to approximately 600 whp/30 psi of turbo boost (See Tech Specs below)
Includes all necessary hardware, brackets, and accessories
Also fits right-hand drive models
Available in Sleek Silver or Stealth Black
Works with stock bypass valve or aftermarket blow-off valve
Optional Subaru WRX/STI Performance Air Intake works perfectly with intercooler kit and provides a rich and aggressive intake tone
Mishimoto Lifetime Warranty
 
Designed for applications that demand the greatest airflow and cooling capabilities, the Mishimoto WRX and STI Front-Mount Intercooler Kit will provide your Subaru with the ability to make the most horsepower and torque possible. This WRX and STI intercooler was designed with a large, 28 intercooler core that provides the maximum cooling capability without excessive pressure drops that will wear out any turbocharger over time.
 
The intercooler features smooth cast end tanks that are CFD tested for maximum airflow with no sharp walls or bends from cut-and-weld end tanks that disrupt airflow. The intercooler provides the best airflow and heat exchange properties for those time attack laps, or a 10-second blast down the quarter mile.
 
The Mishimoto Subaru STI and WRX Front-Mount Intercooler also features four mandrel-bent aluminum pipes for optimum airflow. The hot-side pipes are 2.25 in diameter to keep airflow velocities high, giving your car instant response without excessive throttle lag that plagues many front-mount intercooler designs. The cold side of the system features 3 mandrel-bent aluminum tubing designed for maximum airflow and to match the diameter of your throttle body.
 
The kit is compatible with both stock and aftermarket bypass or blow-off valves.The kit contains everything needed for a worry-free installation, including an application-specific crash bar that both supports the intercooler and mounts to existing points on the vehicle. No cutting or drilling is required to install the crash bar and intercooler.
 
The kit also includes all necessary mounting brackets, including a resistor block relocation bracket to move the resistor block out of the way of the intercooler piping. All mounting brackets will come with applicable hardware, zip ties, and thermal wrap. The kit also includes every coupler and clamp needed for a clean install. For larger-than-stock turbos, Mishimoto has included a larger turbo hot-side pipe that will fit turbochargers with an outlet of 2–2.13 and, as with every Mishimoto Intercooler, this intercooler includes the Mishimoto Lifetime Warranty so you can have peace of mind!!
 
NOTE:
-Reservoir tank may require modification for proper fitment
-Mishimoto recommends that this intercooler kit, with or without the optional air intake, is not used with the stock ECU programming. It is highly recommended that the customer retune the vehicle's ECU after installing the intercooler kit. 
-Power gains will vary depending on the size of the turbo, exhaust system, fuel system, and type of ECU tune that is applied to the vehicle. 
-This kit is rated for approximately 700 whp, or 30 psi of turbo boost. Exceeding these horsepower or pressure limits may require a custom-sized front-mount intercooler. 
-This intercooler kit cannot retain the use of your fog lights if equipped.
 
COMPATABILITY:
Fits 2001-2007 WRX/STI with EJ205, EJ255 and EJ257 Engine codes

Part Number:
MMINT-WRX-01